05-26-2009 07:12 AM - edited 03-13-2019 06:23 PM
Hi,
I am looking for a tcl script which can be used in SRST to provide a simple hunt group.
I would like to have a script which would be run when a specific dial-peer is matched and would then distribute the call to a range of extension numbers, preferable on broadcast, otherwise on a round-robin.
Do you have any examples of this?? I am currently using the alias command however that is limited to 50 entries. So looking to use a tcl script.
06-02-2009 09:53 AM
SRST and B-ACD is not supported scenario with SRST. In order to have B-ACD during the failover, you need to configure CME-as-SRST mode.
Check the URL: Cisco Unified CME Basic Automatic Call Distribution and Auto-Attendant Service (B-ACD):
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/bacd/configuration/guide/40bacd.html
06-03-2009 01:21 AM
Hi Ian ,
I am also facing a same problem ..have you got any thoughts ???
Regards,
Partheeban
06-05-2009 10:09 AM
The solution is in the post above, have you read it ?
06-05-2009 11:08 AM
Thats not really a solution, its an alternative. I need a way of providing a hunt group (not using Alias or using CCME SRST)
06-05-2009 11:13 AM
I believe that is a proper solution.
If you cannot adopt technology for whatever reason, that is not cisco's fault.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide