I use tcl script to control incomming calls (changed standard cisco's example script) so if called number is unvalid, script exits with error code "Invalid number format" (0x1C). It works fine, "show call history voice brief" proves this. But radius server receives start-stop packets for some gateways and stop packets for others. If I use "Call rejected" (0x15) instead of "Invalid number format" there are no start/start-stop packets sent to radius. Can anyone please explain why this happens and if it is possible to exit with "Invalid number format" code and reject the call as in "Call rejected" case without any start/start-stop packets after that. Thanks in advance.
Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...