Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

TCL Script Call Setup

Hello,

I have to find out further information about call setup and control when using a tcl script to play customized ring backs.


When I use a tcl script (application - service) on a voice gateway, and I call the getway, at which time is the script active and


takes control in the ISDN q931 / H323 stack ?

1) at the Q931 Call Alerting ?

2) or after creating a logical h.245 channel ? because the audio have to be streamed to the caller ?

Can I debug this ? How can I see when the script / audio for ringback goes active ?

thx a lot

regards

Patrick

1 REPLY
Hall of Fame Super Gold

Re: TCL Script Call Setup

TCL/IVR developement and debugging is not easy.

However, you can use "debug voice application script".

242
Views
0
Helpful
1
Replies