Does anyone know if it is possible to make a call from a telephone to say, MS Netmeeting? I am able to call from Netmeeting to a extension off an Ericsson PABX via an IOS Voice gateway running on a 2600 but now I need to originate the call from the telephone (POTS) to Netmeeting.
Will it work if I create a VOIP dial peer that points to the IP address of a IP/VC endpoint, like a PictureTel 970 iPower series room system. I know people could call direct through the IP/VC gateway but its just an idea...
As far as I know you don't even have to use a router. Just create a H323 client phone on the callmanager with the ip address of the client running netmeeting. Also setup netmeeting to use an gatway which should be the callmanager's address.
This is good to play arount a bit, but don't think it can really replace a pc or even softphone. It doesn't support low bandwidth codecs, and there is a lot of delay, but it works
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...