Terminate voice and analog modem calls on same trunk?

[nchinetti]

Assuming density is not of primary concern, is it possible to terminate voice and analog modem calls on the same C-T1/E1 trunk on the AS5xxx access server (and stack)? I know terminating analog modem and ISDN digital calls on the same PRI trunk is a no brainer. The termination of voice is for gateway'ing to VoIP.

Essentially, the goal is to multiservice-enable existing POPs (with VoIP-capable AS5xxx access servers) without having to add more C-T1/E1 trunks (assuming they are currently under-utilized for data call terminations).

Thanks!

[bob.short]

Our product team told me that the AS5XXX can be used for VoIP and Modems. If you need assistance with configuring it, please contact our Technical Assistance Center (http://www.cisco.com/tac/caseopen/) as I was unable to find any configurations available online. (I'll see about getting some examples up there for future forum members.) After you get it done, you might want to come back and give us an example here. Thank you for your inquiry.

If any other forum members have some suggestions or can offer Nunzio some help, feel free to post to this thread.

[bob.short]

Here is some more information you should find useful in getting this set up:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/5300/case/qc5300.htm#32815

[nchinetti]

I got the following useful links from TAC ...

1) http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t3/voip5300/voip53_1.htm

2) http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/multi_c/mcprt1/mcdvoip.htm#xtocid2323054