Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

termination in cisco dead air

When the call is terminated, we are having dead air and in a few seconds the calls gets cleared. Cisco as5300 E1 is connected from a Channel bank using r2-digital. In this case, what are the things I need to look closer, or modify to solve the problem. Below is dial peer and voice port config.

voice-port 0:0

translate called 1

echo-cancel coverage 16

compand-type a-law

cptone SA

dial-peer voice 10 pots

destination-pattern .T

port 0:0

prefix ,,

!

dial-peer voice 200 voip

huntstop

destination-pattern 00T

voice-class codec 1

session target ras

dtmf-relay cisco-rtp

ip qos dscp cs5 media

!

dial-peer voice 20 pots

incoming called-number .

direct-inward-dial

port 0:0

!

dial-peer voice 19 voip

destination-pattern 9663T

session target ras

dtmf-relay cisco-rtp

!

dial-peer voice 1 pots

translation-profile incoming prefix

!

dial-peer voice 101 pots

destination-pattern 9663T

direct-inward-dial

port 0:0

1 REPLY
Silver

Re: termination in cisco dead air

The configuration looks good. Are you seeing any errors on the console. If yes what are the errors that you see. Also try enabling the debug commands. This may help in troubleshooting this issue.

134
Views
0
Helpful
1
Replies
CreatePlease to create content