11-07-2005 09:41 AM - edited 03-13-2019 11:07 AM
I have a 2821 voice gateway with an E1 card. I have configured the router for MGCP and want to be able to test it.
How can I do this?
also will the gateway register with the callmanger even though there is no circuit plugged into the E1 card?
11-07-2005 11:18 AM
This document should help:
What version of CCM are you using, make sure it is 3.3(5) or later, as the ISR 2800 routers are new and were not available on earlier releases. If you have an earlier release and do not want to upgrade, then you will have to use H.323.
Chris
11-12-2005 06:13 PM
Well you can't do to much testing without a circut but if you loop it up it should at least show registered with the CCM if config is correct.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide