Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Testing VIC2-2FX S and VIC2-2FXO cards

I want to setup two 2611XM routers with a

NM-HD-2VE ( 3 DSP), VIC2-2FXS, VIC2-2FXO cards.

Can I connect the FXS to the FXO ?

Do I need to have telephones with RJ11 Straight through cables connected to the ports of the VIC's.

Could you point me to somewhere where this scenario is addressed. ( Voice certification test lab diagrams...)

Thank you,

Tom

2 REPLIES

Re: Testing VIC2-2FX S and VIC2-2FXO cards

Hi Tom,

FXS will always connect to FXO. Consider your provider to be FXS, and analog phones to be FXO ports.

You should be able to use a normal telephone cable to connect between the FXO and FXS.

I don't know of any documents that specifically say anything for back to back FXS/FXO, because they are documented separately normally.

hth,

nick

New Member

Testing VIC2-2FX S and VIC2-2FXO cards

Dear Experts

This is going to be my first implimentation of the Voice network and is turning out to be a nightmare.i have reffered all the configuration mannuals , books and videos but still not able to make calls across the MPLS network.Need help urgently to solve the issue.

Here is the senario

PSTN>>>FXO(Cisco2905)>>>>>MPLS Cloud<<<<<<<(Cisco2905)FXS>>>>>>>>Phone

here is the configuration i have done

<<<<<<<<<>>>>>>>>

!

voice-port 0/1/0

!

voice-port 0/1/1

connection plar 2201

!

voice-port 0/1/2

!

voice-port 0/1/3

!

!

!

mgcp profile default

!

!

dial-peer voice 998 voip

destination-pattern 22..

session target ipv4:192.168.220.1

dtmf-relay cisco-rtp

!

dial-peer voice 100 pots

destination-pattern 9............

port 0/1/1

!

on

<<<<<<<<>>>>>>.

!

voice-port 0/0/0

cptone ID

!

voice-port 0/0/1

cptone ID

!

!

!

mgcp profile default

!

!

dial-peer voice 220 pots

destination-pattern 2201

port 0/0/0

forward-digits all

!

dial-peer voice 221 pots

destination-pattern 2202

port 0/0/1

forward-digits all

!

dial-peer voice 110 voip

destination-pattern 9T

session target ipv4:192.168.0.1

dtmf-relay cisco-rtp

!

=====================================

Early response is much appriciated

REGARDS

SANDEEP

621
Views
0
Helpful
2
Replies