Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

The best TRUNK between CCM

what is the best way to connect two CCM?

i have a CCM3.2 and CCM 3.3 on the same LAN/WAN.

thanks

1 REPLY
New Member

Re: The best TRUNK between CCM

Hi Andrea,

Prior to CallManager 3.3, intercluster trunks are implemented as H.323 gateways. On the 3.1 CallManager, you can configure a H.323 gateway that uses Intercluster-Trunk as the Device Prototcol (instead of H.225). For its Device Name, use the IP address of the 3.3 Callmanager. You can then configure a Route Pattern that handles calls destined to the patterns on the 3.3 server, and point that to the new H.323 gateway.

CallManager 3.3 supports three types of trunks for intercluster and H.323 communications:

Intercluster trunks

H.225 Gatekeeper-Controlled Trunk

Intercluster Gatekeeper-Controlled Trunk

In your case, you should use Inter-Cluster Trunk (Non-GateKeeper Controlled). For its Device Name, use the IP address of the 3.2 Callmanager. You then configure a Route Pattern that matches calls destined to the patterns on the 3.2 server, and point that to the new Inter-Cluster Trunk.

Regards,

Michael.

118
Views
0
Helpful
1
Replies