Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

There is no dial tone in an ATA's second line

I have installed CM 3.2.1 configured with MGCP ver. 2.13. The ATA is registered at the CM succesfully, second line is registered by shifting MAC address 2 digits successfully too. There is no dial tone at the second line and there is no way to dialing it.

Gerardo

2 REPLIES
Cisco Employee

Re: There is no dial tone in an ATA's second line

I could be wrong but I thought you need 2.12 version of the ata. That version has support for skinny. Maybe I am wrong but when I load 2.13 it looked like sip and h.323. Can you call the line. Just not getting dial tone?

Thank you,

-Mckee

New Member

Re: There is no dial tone in an ATA's second line

Thank you Mckee, I have made tests with 2.12 and H.323, configurating as a H.323 gateway both lines. I can make call on both lines both never simultaneosly, I have tried by changing the connect mode parameters and It doesn't works fine.

Gerardo

160
Views
0
Helpful
2
Replies