Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

time display on 7941 & 7961

I set the system clock to the correct time but the phones are showing 5 hours earlier. The display was right about a week ago then the vendor changed something and now I can't get the phones to read the right time. No matter what I set the system time to the phones never change. Is there a command to tell the phones what time to display and how do you set it?

thanks

2 REPLIES
New Member

Re: time display on 7941 & 7961

Seems like the timezone is not set correctly

Have you checked the Date/Time-group in the callmanager?

Re: time display on 7941 & 7961

Reset the IP Phone's respective Device-Pool, however be cautious when doing this depending on how many devices are registered at time.

If your large numbers of phones I would recommend this course of action is carried out of hours.

When the phone registers to CCM is should pickup the correct time. As a test you could perhaps reset one IP Phone, and when you are assured this works proceed to restart the others.

Regards

Allan.

Pls rate this post if you find it helpful

263
Views
0
Helpful
2
Replies
CreatePlease login to create content