Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Time of the Day Routing

I have a customer who is going to purchase Cisco 6506 with (1) CMM, and (3) T1 Port Adapter. Each port adapter with have (6) T1 ports. Two questions:

Can CMM be configured to do routing based on time of the day?

will (18) T1s will be too much burden on a single 6506 CMM Module. Is it recommended?

Customer was told by Cisco that Cisco wouldn't recommend to configure 18 T1s on a single blade.

Why Would Cisco has a such technology, but wouldn't recommend it.

Note: Customer doesn't have a Call Manager.

Thanks

2 REPLIES
Green

Re: Time of the Day Routing

The CMM can e configured with time of day routing using CallManager which agent or GW controller r u planning to use if not using CCM? Using H323, MGCP.?

Do u have the doc where that is stated? I dont remember we have published one of those?

Re: Time of the Day Routing

I don't think I would put "all my T1 eggs" in one basket. Ideally, you should have a second 6506 with CMM and t1 cards in it. This way, if one your cores goes down, the PRI traffic can still route.. depending on your MGCP gateway routing.

111
Views
4
Helpful
2
Replies