The clocks on the PC's that our attendants use runs about 2-15 minutes faster than the correct time (depending on when the last time it synchronized). NTP will get the correct time about ever 30 minutes but then the clock will start running fast again. We've noticed that it runs about 2-4 minutes faster every 10 minutes. These are the only PC's that are having this problem and the only thing in common between them is Attendant Console. Has anyone else experienced this?
If you were to turn off the computer for the night, and rebooted it the next day to DOS boot floppy, check the time to make sure it's not the hardware that has the problem. I've had a computer that won't keep accurate time because the cmos battery was getting weak.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...