ToH still toning after service parameter modification CM 6.0
A few weeks back, I changed the ToH timer service parameter to the max of 200000, as it was beginning annoy people on conference calls when users would go on hold.. It worked as expected for a few weeks.. but I got a report this morning that it was toning again, at the default rate of every 10 seconds..I verified, and oddly enough, it is toning. I checked the service parameter and it has not changed, it is still at 200000.. Has anyone ever seen this issue occur? Are there any other parameters that could be affecting this? We are running Communications Manager 6.0.. Thanks for any help!
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4