Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Traffic shaping and Queuing

I want to connect the central office over two parallel 2 MBit/s E1-Link with the branch office. The voice traffic should be prefered, but should not get the whole bandwidth in worst case. Is it possible to put the voice data in the high priority queue for low latency and limit this stream over the 2*2Mbit/s-Link with about 1mBit/s? And how is this solution to configure?

Thanks,

Ben

1 REPLY
New Member

Re: Traffic shaping and Queuing

There are several queueing and traffic shaping features available. You should probably contact Cisco so they can help you determine which one is best for your application.

95
Views
0
Helpful
1
Replies
CreatePlease to create content