When you configure a transcoder or a conference bridge you assign it to a device pool; any devices that use these resources "IP Phones ; gateways and so on use them on the bases how MRGL are assigned. So my question is what it the effect of Device Pool here assigned to the resource itself.
For example if I am using a g711 IPCC at mainsite and an IP Phone at the main site also and both are in the same DP (Phone and CTI RP) and Media resources assgined to the CTI RP is located in a different device pool "instead of being in the same DP as the CTI RP" what is the effect of this and how it is going to work.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.