Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

transcoding in cme3.2

I have a 2801 as a cme and when I make a conference between two pstn parties and a local user, the conference is fine, but when one of the participants is a remote phone in my wan site, the conference can not be completed. I assume this a codec issue because I have g729 with my wan router and g711 to the pstn. I read something about using a network module as a transcoding resource, but I want to know if it's possible and how I use the local unused DSPs of my router.

3 REPLIES
New Member

Re: transcoding in cme3.2

Jose,

it is possible to use the dsps on your 2801 (if you have enough left) for transoding:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide_chapter09186a00802d255d.html

Dragi

New Member

Re: transcoding in cme3.2

I checked this link but it focused on the external NM and I want to know how I do it with the on-board PVDMs

Jose

New Member

Re: transcoding in cme3.2

It's the same thing. If you read the prereqs on that page, you will see that the document applies to both.

Dragi

P.S.

Again, be sure that you have enough dsp resources to configure anything.

118
Views
0
Helpful
3
Replies
CreatePlease login to create content