Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Transcoding problem

Hi, I have a CCM 3.0(9), a catalyst 6500 with E1 Blade and a 36660 with FXS interfaces.

On the port 1 of the WS-X6608 E1 is a PSTN.

If I configure one of the other ports as MTP, when i call an FXS connected telephone, let start a transcoding session between the IP Phone and the 3660.

Why this happen if all the IP Phones, gateways is on the same Region?

Nicola Morelli - CCNP

2 REPLIES
Cisco Employee

Re: Transcoding problem

On the configuration page for the 3660 H.323 gateway in CCMAdmin, did you check the box that says "MTP Required"?

Community Member

Re: Transcoding problem

Ok!

All it's working fine!

Tanks.

101
Views
0
Helpful
2
Replies
CreatePlease to create content