We have several phones that when after answering a call- they hit the transfer soft key, and the extension, the transfer soft key does not come back up - only "end call." It has not been consistent. Any thoughts
Callmanager 4.1(3)sr2 Standard softkey, template, 7940 Ip Phone
What is the difference between the call that has the transfer sofkey available and the one that does not. I think that it has to do with the calls that can handle that phone. In other words if the phone is configured for 2 calls you can only tranfer your current call. In other words, if you have a call, then another one comes in, put the first one in hold, answer the second one, if you try to transfer the second one is not going to be possible.
Why dont u try the following , Lets Say that your IP Phone Extension is 200 , Configure on the Phone another Extension 220. Disable the Call Waiting on both Extensions. Now on Line 200 Configure it to forward on Busy on Line 220.
I think using this method will always keep the < Transfer > Button Available to be used on both Lines.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...