I am trying to have Unity 3.12 transfer to MeetMe conference on CM 3.13a. I have a Unity subscriber with the Conference number as the extension.<br>It successfully transfers to the conference when the conference is running.<br>If the conference is not up it transfers to dead air on a supervised or it hangs up on unsupervised transfer.<br>What I would like it to do is detect the busy condition and take a messge.<br><br>Any ideas?<br><br><br>
What TSP version are you running? I'd highly doubt that we ever tested this in the lab, and outside of changing code, there's probably little that can be done. If we get the TSP version, we'll give it a shot. Got a TAC case? I think you'll need one.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...