Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Transfering calls from a POTS phone

Hi,

I have 2 analogue phones plugged into FXS ports on a Cisco 2821 router. The router is connected to a converged network using Callmanager 4.1(3) and running H.323.

I can make and receive calls between the analogue phones, between them and IP phones and from them over the PSTN. However I cannot transfer calls from them either to other analogue phones or IP phones.

I also get the same problem using other types of routers.

I would be very grateful for any help received.

Regards,

Gerry Seal.

2 REPLIES
Silver

Re: Transfering calls from a POTS phone

I don't think this is possible with H323, but this is available in SIP.

Configure the gateway to use SIP and add this gateway as a SIP Trunk in Callmanager.

Check this link for more details.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a00801541d3.html

Regards,

Anup

New Member

Re: Transfering calls from a POTS phone

Thanks for the help Anup and I will certainly give this a try.

If I use ATA186s as opposed to FXS Ports then Transfer works OK.

Many regards,

Gerry

115
Views
0
Helpful
2
Replies