Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Translating Unallocated/Unassigned DID

I have a customer who has downsized. The customer would like to have all unallocated DID's ring to the Operator. We are currently using MGCP for the gateway.Is anyone aware of a way to do this in CCM without affecting configured DID's?

1 REPLY
Bronze

Re: Translating Unallocated/Unassigned DID

I always use a translation pattern for just this situation. Say you have a range of DIDs from 4000-4099 and an operator extension of 1000. I would create the following translation pattern in a partition accessed by the incoming DID line:

40XX.

then discard all digits (predot)

prefix 1000

This translation pattern would discard the DID number and make it call 1000

If there are actually DID extensions of say 4010,4011 and 4012 then the translation pattern would never be matched because that individual extension is a closer match than the translation pattern. So all existing DIDs work and unallocated DIDs ring the operator.

197
Views
0
Helpful
1
Replies