Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Translation and Called # on the phone display

Is there any way to made translation but leave displayed called # on the phone to number before translation?

And similiar one with RoutePattern:

When i prefix something like "666" on LG level to called #, after Setup/connect phone start to display called number with this prefixed digits. Is there any way to stay display w/o prefixed digits?

7 REPLIES
Silver

Re: Translation and Called # on the phone display

Yes you can, but you would need to do all translations at the Route Pattern level, rather than at the Route list and Route group level. If you do at the Route pattern level, then phones would display the called number rather than the translated numbers.

Regards,

Anup

Silver

Re: Translation and Called # on the phone display

Sorry, I got it wrong. It is the other way. You need to do the translations at the Route Group level within the router list so that the phones will display whatever the users dialed.

Regards,

Anup

New Member

Re: Translation and Called # on the phone display

Yes, Configure the prefix in the Route List

New Member

Re: Translation and Called # on the phone display

Thx!

New Member

Re: Translation and Called # on the phone display

I check it up, when user dialing and waiting for CONNECT from PSTN side - display shows correct short number, but after connect the number changes to long one. On isdn site it looks like:

- dialed #: 12345678

- called to PSTN: 6666666601234567

(6666660 is IVR/IN telco operator number)

and and i think becouse ISDN gives "connected" with called # no "real Called ID".

Is there any way to made it displaing just 1234567 ?

Sth like - always how dialed # or something ?

TIA!

New Member

Re: Translation and Called # on the phone display

Any hints about translation case?

To set up Phone to display shows number "before translation" ?

Silver

Re: Translation and Called # on the phone display

Try changing the "Connected Line ID Presentation" setting to "Restricted" in the corresponding route pattern and see if that helps.

Regards,

Anup

192
Views
9
Helpful
7
Replies
CreatePlease login to create content