Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

translation routing on DMS100 PIM

I am looking for some tips/gotchas in configuring translation routing on a DMS100 pim (CompuCall X.25 link). This is not covered in the SMGS for this particular TDM PBX, and I'd like to get some more specific information on it before I proceed with programming and provisioning. I've done these on Meridians with MeridianLink, and on Avaya Definity PBXs with ASAI, but not a DMS100, which is a very challenging switch. As it is completely outsourced at the client site, I'd like to make sure we provision correctly before we get into the thick of it.

186
Views
0
Helpful
0
Replies