Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

translation rule

Dear all

i am facing a problem with the translation rule

i need the translation rule in a way if i dial the number 9 i need the rule to dial 4 digit then pause for 5 seconds then dial 6 extra digit is that possible ?

if not is there another way?

in other word i need to dial lets say "5391(4sec pause)123456" can this be accomplished by dialing only one digit?

tks

2 REPLIES
Silver

Re: translation rule

If you are wanting to send this call out to a telephony leg, then it is possible (not possible with ISDN) .... what you should do is put commas in your replacement pattern 5391,,,,123456 will have the effect that you desire, but only if going out analog or cas interfaces.

New Member

Re: translation rule

tks for your reply

i tried this but the translation rule doesn't take the commas for pause any other suggestion

tks

108
Views
0
Helpful
2
Replies