I have 2 CCM clusters. Cluster A has Extensions in the range 4XXX, site B has Call Park #'s of 4XX. For the phones at site B to call site A, I have a RoutePattern of 4XXX to an intercluster trunk.
This gives callers fast busy. Even if I do not allow the calling extension access to the Call Park partition. If I define explicitly the number being called it works. It will not work with the 4XXX pattern though.
Do I need to change the Call Park number range for this site?
I don't quite understand what could be happening. In site B whether you have the 4xxx or 4000 when the call is sent to A it is called party is 4000. Can you look at the traces and see if the call is getting busy from site B or site A cm cluster? Another thing is in site A ccm assign a CSS to the intercluster trunk deivce representing site B that does is not allowed to call the park range.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.