Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trouble Configuring Message Notification

I configure message notification in the Cisco Unity 2.4.6 with CM3.1, all works fine, but when the unity call to the phone, i answer but when the operator ask to dial my id code, the phone not send the digits.<br><br>I´m using a 2620 Gateway with analog ports (FXS &FXO)<br><br>

1 REPLY
Anonymous
N/A

Re: Trouble Configuring Message Notification

Make sure that there is a dtmf-relay enabled dial-peer in the GW that has a destination-pattern that matches the DN of the Unity port that is dialing out for notification.

You can do this be either creating separate dial-peers for each Unity port, or just make the destination-pattern of one dial-peer fit the extension numbers of all Unity DNs.

Steve Olivier
Software Engineer
Cisco Systems

85
Views
0
Helpful
1
Replies
CreatePlease login to create content