Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Trouble with WVIC-2DSU-T1

I have a 3640, with a NM-HDV, which in turn has a WVIC-2DSU-T1. It also has 4 of the 5 dsp slots filled.

I am trying to configure this box as a T1 PRI ISDN to VoIP gateway, and am having trouble making it work.

1. "sh voice dsp" shows:

test#sh voice dsp

DSP DSP DSPWARE CURR BOOT PAK TX/RX

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT

==== === == ======== ======= ===== ======= === == ========= == ===== ============

2. test(config)#controller T1 1/0

^

% Invalid input detected at '^' marker.

(^ is under the t of controller).

From a sh diag:

Slot 1:

High Density Voice Port adapter

Port adapter is analyzed

Port adapter insertion time unknown

EEPROM contents at hardware discovery:

Hardware revision 0.0 Board revision UNKNOWN

Serial number 0 Part number 00-0000-00

FRU Part Number: NM-HDV=

Test history 0x0 RMA number 00-00-00

EEPROM format version 0

EEPROM contents (hex):

0x20: 00 CC 00 00 00 00 00 00 00 00 00 00 00 00 00 00

0x30: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00

WIC Slot 0:

HDV firmware: Compiled Wed 16-Jan-02 20:43 by pkonda

HDV memory size 524280 heap free 195657

Is the WVIC-2DSU-T1 suitable? Is it working? If so, could anyone please tell me how to enable it?

2 REPLIES
Cisco Employee

Re: Trouble with WVIC-2DSU-T1

No.. you need to use VWIC-1MFT-T1 to get the T1 support for Voice.

Pl. visit following link for what other modules which can work with NM-HDV

http://www.cisco.com/warp/public/788/products/hdv_netmod.html

Cisco Employee
117
Views
0
Helpful
2
Replies