2811 on 12.4(3c), MGCP w/ CCM 4.0(2a)SR2b. My PRI dropped for 2 minutes yesterday and when it came back up, incoming calls resulted in reorder. Q931 debugs showed the call presenting to the router, but the router was dropping the call immediately, sending a Temp failure code (I didn't capture the output). The behavior has been fixed by having telco remove the offending channel from the hunt group.
I'll reload the router tonight, but what are the possiblities? The T1 controller card is damaged? What further troubleshooting can be done?
My guess is that all you should have to do is reboot the router. Sometimes a channel will get confused and need to be bounced. My CCM is behind a Nortel SL-100 so I use the PBX commands to bounce a channel if needed. The telco should have been able to do that for you. There might be an IOS command that would allow you to do the same thing (busy the channel then return to service).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.