I am in the process of planning a VoIP solution for a customer. They require that I can monitor E & M trunks using snmp. In the future they want to migrate to VoIP on the lan and wan. I have narrowed the selection down to a 3660 router with 16 E & M trunks. My question is, can I place individual E & M trunks into a trunk group, much like you can with a traditional PBX. Thanks
Well, with analog E&M ports, you don't exactly create "trunk-groups" in their traditional meaning. But with dial-peers you assign destination patterns which are used to route calls based on the dialed number, and with multiple peers you can have the same pattern(s) go out the same groups of ports. So for example, you could route numbers 4XXX to ports 1-8 and 5XXX to ports 9-16, and 6XXX to ports 1-16. It's completely configurable from the Cisco IOS command line interface.
I'm not a big NMS guy, but standard Cisco IOS SNMP rules apply, and I know that there are many voice related features and interfaces that can be monitored, and I must therefore assume also can be configured to send traps.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.