Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

trunk line appearance in a ccme

I have a 2801 with CCME software and a 4FXO Card. Users call the PSTN dialing 9+number but they do not see when, for instance, there is no outside line available. They realize this when getting a fast busy signal, but I wonder if there is a way to have each FXO port an appearance in the ip phone buttons.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: trunk line appearance in a ccme

Yes, you can use the "trunk" command. Please see the following link.

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_command_reference_chapter09186a0080611369.html#wp1082096

Hope this helps. If so, please rate the post.

Brandon

3 REPLIES

Re: trunk line appearance in a ccme

Yes, you can use the "trunk" command. Please see the following link.

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_command_reference_chapter09186a0080611369.html#wp1082096

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: trunk line appearance in a ccme

Thank you very much Brandon, is there a similar feature in CCM?

Re: trunk line appearance in a ccme

No, I don't know of a way to achieve this in CCM.

Brandon

145
Views
0
Helpful
3
Replies
CreatePlease to create content