In PRI, there is five numbers as hunt group. when the first number is busy, next call to the same number, uses second number in the hunt group. what is the best method to define trunk number (in hunt) in the CME which only shows main number in receptionist phone? Also if there is 50 DID number, would you please send the template configuration in CME in order to have DID?
Should I use ephone-dn for each DID number or define dial-plan or something else?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...