Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trunking between CM 3.1 and cme 3.4

Hello!

I'm not really familiar with the IP telephony coz im focusing more on routing & switching. But i do have knowledge about ip tel. I just need help if this is possible to communicate each other via IP WAN(not PSTN). IF it works, what are the parameters i need to configure between the CM and CME. And also for the voice gateway at the CM side.

Regards,

-john-

1 REPLY

Re: Trunking between CM 3.1 and cme 3.4

It is possible to configure CCM and CME to communicate over the WAN. Please see the following link for configuration details.

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00804ad858.html#wp1001001

Hope this helps. If so, please rate the post.

Brandon

104
Views
0
Helpful
1
Replies