Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Two callmanagers, 1 Gateway

is is possible to have 2 callmanager clusters share 1 gateway? gateway is a a vg200 configured on first ccm cluster as an h323 gateway. It has two pri's terminated on it each with separate blocks of DID's. We need to add another callmanger cluster to the mix to support a new customer and I was wondering if I could continue using the same gateway. My voip dial-peers on the gateway now are someting like

dial-peer voice 100 voip

preference 1

incoming called-number .

destination-pattern ....

progress_ind setup enable 3

voice-class codec 1

voice-class h323 1

session target ipv4:172.16.0.4

dtmf-relay h245-alphanumeric

ip precedence 5

I was thinking I migh could do something with the destination-pattern part of the dial-peer config to route calls to a certain block of DID's to another callmanager cluster.

  • Other Collaboration Voice and Video Subjects
2 REPLIES
New Member

Re: Two callmanagers, 1 Gateway

I cannot think of a reason why this would not work as long as, as you mentioned, your destination pattern gets more specific

dial-peer voice 100 voip

preference 1

incoming called-number .

destination-pattern 6...

progress_ind setup enable 3

voice-class codec 1

voice-class h323 1

session target ipv4:172.16.0.4 (clusterA ccm 1

dtmf-relay h245-alphanumeric

ip precedence 5

dial-peer voice 101 voip

preference 2

incoming called-number .

destination-pattern 6...

progress_ind setup enable 3

voice-class codec 1

voice-class h323 1

session target ipv4:172.16.0.5 (cluster a ccm2)

dtmf-relay h245-alphanumeric

ip precedence 5

dial-peer voice 200 voip

preference 1

incoming called-number .

destination-pattern 3....

progress_ind setup enable 3

voice-class codec 1

voice-class h323 1

session target ipv4:172.17.0.4 (clusterb ccm1)

dtmf-relay h245-alphanumeric

ip precedence 5

dial-peer voice 201 voip

preference 2

incoming called-number .

destination-pattern 3...

progress_ind setup enable 3

voice-class codec 1

voice-class h323 1

session target ipv4:172.17.0.5 (clusterb ccm2)

dtmf-relay h245-alphanumeric

ip precedence 5

Even if it works obviously another consideration is if 2 PRI's were needed for company A, will 2 PRI's be enough for comapnies A and B ?

New Member

Re: Two callmanagers, 1 Gateway

Thanks.

The two pri's are not needed for company A, just got two for redundancy. Plan is to use the vg200 and two pri's for trunking to PSTN until we need more then upgrade to a as5350 or some other device to terminate the PRI's.

This is for an ip centrex offering and the second callmanager cluster is for a big customer that wants more control over their own phone system but doesnt want to have to deal with the local rboc for trunking.

83
Views
0
Helpful
2
Replies