Arent you able to ping the PCs connected on the other side ??
Can you post the config of both the routers ? also the show ip route o/p here ?
The best thing here would be using a /30 subnet mask for the Serial connectivity between the Links connecting the router instead of /24.
In normal working live production environment u cant afford to loose a /24 for just configuring the WAN interfce since u will use 2 ips here and the other remaining ips will be wasted cant be used anywhere else.
so better to try out with general recommendations and best practices.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...