Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
206
Views
0
Helpful
3
Replies

tx-ring for frf.8

ciscojock2002
Level 1
Level 1

‎03-08-2004 01:51 PM - edited ‎03-13-2019 04:10 AM

In an frf.8 environment, virtual templates are used for atm--->frame-relay qos. doc-cd says that ppp-multilink interfaces automatically enforce a hard limit tx-ring 2.....my question: is it still necessary to reduce the tx-ring on the atm subinterface/vc?

thanks!

Labels:
0 Helpful
3 Replies 3

pbarman
Level 5
Level 5

‎03-08-2004 01:57 PM

Under ATM interface a tx-ring-limit of 3 is enough, and is the recommended value for slow-speed ATM links.

Thanks,

Partha

0 Helpful

jcmartin
Level 1
Level 1
In response to pbarman

‎04-09-2004 08:56 AM

Partha,

Is any special configuration needed on either the FR or

ATM endpoint when running across a FRF.8 Translational Mode VC?

0 Helpful

jcmartin
Level 1
Level 1
In response to jcmartin

‎04-11-2004 06:27 AM

Just reread my message, I meant to say FRF.8 Transparent mode VC.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents