I am just starting out and have a UC500 to learn on. I am trying to connect to my ISP using PPPoE through an Alcatel Speedtouch Home DSL modem in relay mode, but when I try to configure the UC500 from the GUI ...the PPPoE settings are greyed out. Can you point me in the right direction?
Symptom After the WAN interface on the Modify Internet Connection dialog is disabled and reenabled, the PPPoE check box becomes enabled again even though a firewall configuration is present. Because of this problem, Cisco Configuration Assistant disables the PPPoE check box if it detects a FW/NAT configuration under FA0/0.
Workaround To configure PPPoE, you must first delete the current FW/NAT configuration, then configure PPPoE, and finally reconfigure FW/NAT by choosing dialer0 as the outside interface.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...