Does anyone know how to configure a meet-me conference on a UC500 via the CLI? The configuration notes for CME 4.2 don't seem to apply, since the UC500 does not have the required dspfarm pool. I would appreciate any help! Thanks, Dennis.
Here's the config I use in a customer install, to support 2 x 8 parties G.711 conferencing only. There is only one set of ephone-dn for conference configured. The remember to cofngire the meet-me softkey in ephone-template.
This configuration also helped me, with a problem I had with the dspfarm not registering with SCCP on a UC500, except that I am using multi-party ad-hoc instead of meet me conference.
Everything now looks fine but when the folks press the Confrn softkey they get a message "no line available". The only thing I haven't tried is resetting the entire system.
I've attached the whole configuration in case there is something I've missed, but I think I have covered everything I could find in the documentation. If you could look through it when you have the time I would appreciate it.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.