Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UCCX Supervisor CAD question

                   Hi All,

                            I have a call center manger that uses cisco supervisor CAD to manage the agents states. At times it get real busy and as you know when you are on a call and you get a new call the agent is marked not ready. Is there a way to change multiple agents state with the touch of one button.

Thank you

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

UCCX Supervisor CAD question

Hi Curtis,

No, Supervisor has to select the individul Agents and force them to go to Ready\Not Ready state.

Agents can go to Not-Ready state by themselves or while answering the non-ICD calls. They will go to Talking state only when handling the ICD calls.

Hope it helps.

Anand

Pls rate helpful posts !!

1 REPLY

UCCX Supervisor CAD question

Hi Curtis,

No, Supervisor has to select the individul Agents and force them to go to Ready\Not Ready state.

Agents can go to Not-Ready state by themselves or while answering the non-ICD calls. They will go to Talking state only when handling the ICD calls.

Hope it helps.

Anand

Pls rate helpful posts !!

313
Views
0
Helpful
1
Replies
CreatePlease to create content