Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UCM bootup error: Err 14: Automatic removal of fake floppy failed

I need help in figuring out why I'm getting this error on bootup. I started getting this error after updating the OS to 2000.4.6sr9. The previous OS ver was 2000.4.4asr7. The server is an MCS-7815-I2-IPC1. CM ver 4.1.3sr8a.

The error is the following.

Err14: Automatic removal of fake floppy failed.

Press any key

The server does not have a floppy drive. Also, the floppy drive is disabled in the BIOS.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: UCM bootup error: Err 14: Automatic removal of fake floppy f

Hi!

Can yoy please try the following?

Reboot server,go into the BIOS setup(F1) and choose "Load Default

Settings"and then "Save Settings", the correct drivers will load at reboot and

server will come up clean.

This is documented in this bug:CSCsg07275

Hope this helps!

Regards,

Teresa.

If it helps, please rate! :)

Regards, Tere. If you find this post helpful, please rate! :)
2 REPLIES
Cisco Employee

Re: UCM bootup error: Err 14: Automatic removal of fake floppy f

Hi!

Can yoy please try the following?

Reboot server,go into the BIOS setup(F1) and choose "Load Default

Settings"and then "Save Settings", the correct drivers will load at reboot and

server will come up clean.

This is documented in this bug:CSCsg07275

Hope this helps!

Regards,

Teresa.

If it helps, please rate! :)

Regards, Tere. If you find this post helpful, please rate! :)
New Member

Re: UCM bootup error: Err 14: Automatic removal of fake floppy f

Thanks Teresa. It solved the problem.

231
Views
0
Helpful
2
Replies
CreatePlease login to create content