Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Unable to configure dial-peer

Dear all,

Was wondering whether anyone can advice me on this. I currently have a 3640 router and the IOS is 12.4 (13b) and i am unable to configure the voip dial-peer as it says my command could not be recognise. When i try to configure the pots dial-peer, it is fine until i write mem. The error msg align-fatal will appear and the router will then be reloaded.

Any advice on this?

3 REPLIES

Re: Unable to configure dial-peer

Can you post the output of sh version

Narayan

Re: Unable to configure dial-peer

Hi

As Naryan correctly probed the IOS feature set/version could make a difference out here..

regds

New Member

Re: Unable to configure dial-peer

Found out what the problem is. The IOS i was using doesn't support gateway function. Thanks anyway.

142
Views
8
Helpful
3
Replies
CreatePlease to create content