I recently bought a 1760 with PVDM installed in it. I also purchased a MFT-T1 card for PRI/CAS configuration. I see the PVDM in slot0, and can configure the controller T1. But, When I try to configure PRI-group command the router comes back with an error that says that T1 does not have data capabilities?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.