at user device profile configuration page for my EM, there is a link (uppper right) "Subscribe/Unsubscribe Services". once the EM profile is subscribed to EM, I can logout of EM from the phone.
1. my user ID has been associated with EM device profile. or EM profile has been assigned to my user ID. Then why the EXTRA step is needed to subscribe EM on my EM profile?
2. at Device Profile Default Configuration for 7961, on link "Subscribe/Unsubscribe Services", I noticed the error of not having EM subscribed. 7960 has EM assigned. This may explain why logout was not present on 7961 phones. I have yet changed the setting for 7961 device profile.
but can anyone verify it's the cause?
and do I have to reset all 7961 phones when EM is assigned to 7961 device profile?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...