Unconfigured ports on a VG224 or VG248 show up in the Callmanager's Event Log as Stop Errors. Any way to suppress or filter these? I have roughly a hundred voice gateways with countless unassigned ports. It makes the Event log unusable to viewing other status.
Thanks for the info. Unfortunately this still sound like a monumental job for a site with over 1000 unassigned ports. I think we'll opt to just go ahead and configure the ports, though without a DN (until we need it).
This actually works well. Here's the best approach I've found:
Bulk Admin Tool->Device>Phones>PhoneReports.
Query VGC Phones and include Device Name. Sort the data in Excel and locate unassigned ports (description will be empty and no DN). Use this to bulk import (VG248 gateways only) back into Callmanager. Voila - no errors.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...