Unity 2.3.4.102

[larry]

had to restore because of drive failure where exchange db was stored and lost some call handlers.

I need to get this system up to 3.1 in 30days.

Is it possible to get the Services Pack to upgrade the system to 2.3.4.104

The 2.3.4.104 version supports the Import/Export utilities from what I have been able to find out.

The Unity system uses a Dialogic Bb. to communicate with the PBX, Im looking at a completly new Server to replace this one I was hoping I didn't have to recreate everything from scratch on the new 3.1 system

Thanks,

Larry Whitlock

[lindborg]

You can run the dbExport on 2.3.4 102 - the 104 was just the oldest version I tested against at the time I posted it. There weren't any DB changes or the like that would cause problems between 102 and 104.

However, if some of your call handlers are lost I suspect your DB is going to be in bad shape - be sure to run dbWalker off the 2.x page on AnswerMonkey and work through it until you get a reasonably clean run. The export/import process will fail miserably if you try backing up a damaged system and then restoring the data onto a clean install of 3.x...

[larry]

thank you!