Hello<br>After we upgrade to Unity 2.4 Build 220.127.116.11, the system has been unstable.<br>1. When you try to call a user and use a call handler the system sometimes just hangs up.<br>2. We are not able to run any reports<br>3. We are sometimes having problem playing the voice mail over the phone<br><br>We are running on an NT4 server and CCM 3.08<br><br>Regards<br><br>Ketil Johansen<br><br><br>
I don't have any snappy answers for you out here... we certainly don't have any known problems in 2.4.6 (running on lots of sites) along these lines other than there are some bugs in the reports engine. Once a report gets hung up in the queue, it prevents any reports behind it from executing. You should be able to flush the queue... do ALL reports fail? That would be unusual.
dropping calls... are these release transfers or what's the sequence here? when you say 'problems retrieving voice mail' what do you mean? I'm assuming you're running a 18.104.22.168 of the AvCiscoTSP?
You should really open a TAC case and get someone looking at these. Could be some TSP/CM config issues on dropping calls that should be straight forward enough to troubleshoot.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...