I have created mulitple call handlers. The call handler is associated with an extension within CM 3.1(3). When you press the 1 key you are supposed to be attempted to transfer too. This is not occuring. All of the "Attempt to transfer too's" are being sent to the greeting of that subscriber rather than the phone. Any ideas? By the way this is in production now. So any help will be greatly appreciated.<br><br>
the most common cause of this is the wrong transfer rule being used on the destination call handler (i.e. the guy you have mapped to the "transfer to action"). I always suggest activating the alternate transfer rule and testing with that so there's no possibility of the wrong one being trigger.
There's also be a few folks on 3.1(3) and 3.1(4) that seem to have some issue with the default call handler template. If they create the destination call handlers copying, say, the operator call handler instead it works. I'm waiting to be able to get into a system that has this issue so I can check it out and open a bug record if necessary as I can't reproduce this on my test systems. If you see this is the case and you have remote access via WTS or pcANYWHERE on your box, ping me... I'd like to pop in and check out a few tables in your SQL database.
In the Unity SA, bring up the settings for the destination call handler. Then go to the Call Handler > Call Transfer page. At the top of the page, there's a drop down list "Transfer Rule Applies To". For each of these, Alternate, Standard, and Closed, make sure that the "Transfer incoming calls" is set to ring the message recipient or ring a subscriber. Could be the problem is that one of those is set to "No (send directly to this handler's greeting)".
Thanks for the help guys. The issue was when the trees was created and the call that was transfered to the subscriber. The subscriber needed to allow the call to be transfered to there extension not sent to the greeting. I would have provided you access but the customer has no means for it.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...