We have a 3.13 install with 8 ports. We need these to be all CCM ports. We have a dual int licence, but only require a IP CCM integration. We chose the Call Manager as the switch in the setup.exe and we now have CCM in the "switch" section as well as the "ip switch" section which I think is our problem. We can not get any ports avail on either. TSP test works fine and connects.<br>Can we delete the CM switch ? Is this causing us the problem ? Should we run the install again ?<br>Thanks<br><br><br>
Was this a dual integration before and then converted into an IP only? Check the registry under HKLM\Software\Active Voice\Miu\1.0\Initialization. do you have more a single switch 0 entry or is there an additional switch 1 entry too?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.