Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unity 4.0 and VPIM with BCM

We are able to send a message to BCM, however, when we reply back we get a ndr saying that there is no matching subscriber, even though there is. It had worked before so we're thinking it's something else.

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: Unity 4.0 and VPIM with BCM

You might want to check out my doc on the VPIM Transport Event Sink:

http://www.answermonkey.net/Documents.htm

This is very good also:

http://www.answermonkey.net/App_Unity401TOI.htm

Are you sure the mail is getting to an Exchange server which has the Sink installed? If you are getting that far is it getting converted to IMCEA format by the Sink for routing to the Voice Gateway Connector?

Keith

1 REPLY
Gold

Re: Unity 4.0 and VPIM with BCM

You might want to check out my doc on the VPIM Transport Event Sink:

http://www.answermonkey.net/Documents.htm

This is very good also:

http://www.answermonkey.net/App_Unity401TOI.htm

Are you sure the mail is getting to an Exchange server which has the Sink installed? If you are getting that far is it getting converted to IMCEA format by the Sink for routing to the Voice Gateway Connector?

Keith

103
Views
0
Helpful
1
Replies