I know that everyone is going to tell me you can not do it. I know there is a work around I can play with to do Multi Tentant. If Cisco come up with somthing soon I will crap can the Octel 350 and go with Unity.
Until then you VoIP hot shots should know or point me in the right directions. Do not get me wrong I can crawl in and out of almost any Nortel or Avaya switch and fix it. I took the Unity class and can install it but that is about it. If you point me in the right direction I can figure it out from there.
Check out the "Audiotext applications in Unity" doc on the Documents page of www.CiscoUnityTools.com - I cover the ins and outs of how close you can get to tenant services with Unity 4.0x (and more to the point where you'll run into trouble). That should get you in the ballpark anyway.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.